If the case and doors are carried out from a chipboard, for them use special furniture loops. As a milling cutter or a drill with a drill crown choose a round groove for a cup of such loop.
After all sometimes it is necessary to remove several times them and again to hang to achieve the best result. Self-tapping screws are twisted in previously drilled openings of smaller diameter.
For wooden doors usual loops butterflies are used. On a fastening place surely manual milling cutter a little tree gets out that to drown them level with a preparation surface. It will make minimum a gap at installation of doors to a case.
Oar doors. Eat space as near a case nothing can be put more, but some to liking such traditional design. On a high door there are usually enough three couples loops. It is in addition possible to use closers and magnets.
It is possible to collect lining on glue and to allow it to dry, having clamped in clamps. The received board can be used and without frame. Details from lining are recommended to be ground and processed wood stain.
Sliding doors. Use rather difficult system of rollers and directing. Behind their production it is necessary to address to the specialized companies, and meanwhile aluminum directing them quite shaky and in general all design of sliding doors demands constant attention.
The door for them need to make of the integral sheet of thin material (plywood, plastic, a chipboard), then they without any rollers will move quite freely on grooves of the directing. For easier course in grooves it is possible to lay a plastic corner (such are used as channels for an external electrical wiring).
The ready door collected from scraps of boards or lining needs to be strengthened from the back party a cross-piece (but to watch that it did not rest against shelves, disturbing closing of a door), and with external it is possible to decorate with platbands.