For simplification of a vvorachivaniye of a nut it is possible to set the course a tap on 12mm. The step of a tap is equal to a carving step on a nut-vvertyshe.
Smoothed out a table an emery paper, at first, 80-which, then smaller - 150-which. The table edge and whetstones I made a little rounded off.
Having sawn a table-top by the table sizes I was accepted to a zapilivaniye of the ends of a bar under 45 degrees.
The bar is necessary for giving of rigidity of a table-top. We let it on table perimeter from the lower party. Without whetstone the table-top will cave in.
We drill openings in a table-top under vvertysh. Diameter of a drill — 10 mm. Diameter of a nut-vvertysha — 12 mm.
Likely when I will do one more table, I will use rail-posts. They happen the different size. It is desirable to be used rail-posts with a diameter more than 70 mm. Them also to fix on screws.
Instead of metal legs it is also possible to use a square bar or ready rail-posts which the ready are on sale.
It is registered in Federal service on supervision in the sphere of communication,
After careful polishing started a table covering a varnish.
The table is ready and costs on legs. We start its polishing and a covering it is delicious.
type-setting wooden furniture board length width 60sm and length 3m (was not less),
On a reverse side of a table-top we mark places of fastening of legs and an opening.
I will tell about how it is possible to make a kitchen table the hands with a wooden table-top at the minimum financial expenses.