There are mills simple, created from a uniform piece of metal, there are type-setting. Type-setting have a shaft — a basis, some set of various cutting planes, a set of washers of different thickness. From these details it is possible to create independently demanded relief.
Now, at installation on preparation and pressing the top part, the mill will enter a detail on the exposed distance.
Not such difficult requirements, but their performance — pledge of good work and safety. Well and the main requirement — the milling cutter should be conducted exactly, without breakthroughs, pushes. If the strong beating is felt — change rotation frequency. Most often it should be reduced, and in general it is worth being guided by recommendations of the producer (is on packing).
There is a quantity of types of nozzles for a milling cutter which are used most often.
Do mills of different metals and alloys. For processing of soft wood — pines, ate, etc. — use usual nozzles (HSS), for rigid breeds — an oak, a beech and others — from rigid alloys (HM).
Work as a manual milling cutter on a tree will be easier and pleasant, products will turn out normal quality if to satisfy some conditions:
Work as a manual milling cutter on a tree assumes existence of a quantity of mills. It is small part of that exists