We pass to a covering stage with cloth which has to cover both a table-top, and boards. Fabric fastens to a table-top bottom brackets. Each board has to be fitted densely, with the maximum stretch on all length. For this purpose:
For fixing when sealant dries, it is possible to fix a plate from below short self-tapping screws.
Rubber is glued to wood by means of all-purpose construction adhesive, the main thing – to apply substance on both stuck together surfaces and to press most strongly. After drying of glue it is necessary to cut off rubber according to the drawing – for this purpose it is possible to use the simple sharp knife moistened in soap water. Meanwhile we do not fix sides on a table-top, it is worth passing to this point after a cloth stretch.
Then it is possible to start production of legs for a table. We cut a tree on whetstones of the necessary sizes. There is a set of options of registration, for example:
The remains of fabric are cut off or accurately fixed. Boards fasten by means of self-tapping screws or through bolts.
Here accuracy up to millimeter is important: errors can become the reason of disagreements subsequently. From tools for this purpose it is necessary to use a saw or an electrofret saw.
The plate of a table-top fastens to a framework. For this purpose it is possible to use silicone glue-sealant. It is best of all to apply this glue evenly or even pointwise, and to put a table-top on it in 4 hands that glue was not smeared.
After that it is possible to make boards. We cut off wooden preparations, but thus it is impossible to forget that on end faces leather slips will be pasted. Therefore if they were not considered in the drawing, it is necessary to reduce width of each board by thickness of the available slip.